linkmustang

this weather blows guys it raining my idea is to order a gasket kit for the 5.0 so all the gasket next week end lot me know guys

linkmustang

looks the same i was sick the last few days then the weather was crap so at lest i got the starter off and a few bellhouing bolts of but some are so damn tight so ya

but i got my 4 3inch u bends in wich is good

ososlohatch

werd well keep us updated.... are you ganna replace gaskets and ---- since your taking the motor out ?

linkmustang

yup i will
looks like the trans will stay in and and drive shaft will stay attached and what is left of the h-pipe but the bolts are so damn tight

ososlohatch

use some pb blaster

linkmustang

o i will

linkmustang

been sick lately soo little work was done

linkmustang

FPP-2922RS Rear Main Seal, Fluoroelastomer, 1-Piece Type, Ford, Small Block, Each $14.88

MIL-41003 Oil Pan Gasket, 1-Piece, Rubber, Steel Core, Ford, Each $27.95

SUM-853011 Ignition Coil, High Output, Square, Epoxy, Black/Red, 40,000 V, Ford, TFI, Each $27.95
just order that


i have one bellhouseing bolt left and the moter mounts

USS

Good job man. Just some advice for you.

The mounts are attached to the engine by two bolts, and those mounts are attached to the frame by one bolt. Just loosen the mounts from the frame, rather than from the engine. It's a lot easier. Good luck

linkmustang

thanks well little update only moter mounts and ground strap and the p/s we will pull the engine sat if the weather is good