Ok...I have a b16a3...going ot be running a t3/t4 .57 trim turbo at 6 psi....with a tiny 4'' high 27'' long 3.5'' thick intercooler.

I want to install an oil cooler inline to my turbo as well as an oil restrictor. How would I go about setting this up? I don't ahve the cooler yet, I was planning on getting a used tranny or oil cooler from ebay.

would It go: T-fitting connected to block--->oil pressure sensor--->line going from T fitting to oil cooler--->exit line from oil cooler to turbo with inline restrictor?

Would I run into any problems with fittings or oil pressure problems? (i heard that sometimes VTEC doesn't kick in with the addition of an oil cooler)

 

I know we all made the mistake. but wrong forum.. the answer to your question summit racing sell filter adapter for this purpose. they are about $25

 

Damn I thought i was in forced induction....can a mod move this?

And damn again...I completely fucked up the post.

What I want is an oil relocation kit AND an oil cooler AND an oil restrictor....Ideally all inline to the turbo feed.

Thanks for the help though...

 

oil feed ---> oil cooler ---> resritctor ---> turbo

you could switch the cooler and restricter and it would make a difference.

i put it after because the oil would have more time to sit in the cooler that way.

 

I'd much rather see it run though the oil filter section. I just don't trust that small oil line to flow a bunch of oil. I got a summit oil filter relocation kit, and just put in an oil cooler in line with it. Works well.

 

Thanks for the input.