Clocking T25
#1
Clocking T25
Is it possible to clock the exhaust housing on a DSM T25? I know there is a snap ring to clock the compressor, however the guy who TIG'd my manifold fucked it up and didn't weld the flange on at the right angle. My drain/feed is off about 15-20 degrees (not that bad), but that damn compressor outlet that bends off hits the radiator. I could just turn the compressor, but I'd like to kill two birds with one stone. I did seach and could find it. Thanks guys,
Colin
Colin
#3
Re: Clocking T25
You need one of these.
http://www.harborfreight.com/cpi/cta...emnumber=45327
This is a life safer when you have turbos that has snap rings to hold the compressor housing on.
http://www.harborfreight.com/cpi/cta...emnumber=45327
This is a life safer when you have turbos that has snap rings to hold the compressor housing on.
Thread
Thread Starter
Forum
Replies
Last Post