clocking jdm t25....won't budge
#1
clocking jdm t25....won't budge
I have a jdm t25 and all the bolts are loosened, I soaked it in PB blaster, and the damn thing will not budge. I only need a couple degrees too! Tomorrow I'll be trying heat. If that doesn't work I swear I'll throw it away! Doea anyone have any suggestions?
#6
Re:clocking jdm t25....won't budge
Dissasemble it and see if theres a pin that holds the alignment. I know the 14b's have it. Thats proboly whats killin you its a tiny bitch too I beat the crap out of mine then I took it apart and there it was. It actually fell out and now I can spin it all I want.
#8
Re:clocking jdm t25....won't budge
i just did the same thing on sunday and it would not budge, so i got a hammer and i beat the ship out of the turbo and i swear too god i actually slammed it on the ground a few times and it finnally came off, it was just so rusted.
#9
Re:clocking jdm t25....won't budge
I tried taking out all of the bolts but some of them can't come out all the way because it runs into the center section.
I think tonite I may try the slamming on the ground. Will be taking it to work wed. night to heat it up.
I think tonite I may try the slamming on the ground. Will be taking it to work wed. night to heat it up.
#10
Re:clocking jdm t25....won't budge
Well I heated it up tonight, then used some leverage in each of the turbo outlet/inlet holes and got it rotated. Looks like this turbo isn't for the lazy. The mani/turbo combo was made for a/c...and I dont have that or a full radiator so space is the last thing I need. Anyone want to buy a hks mani and/or a jdm t25 turbo? Willing to trade!
Thread
Thread Starter
Forum
Replies
Last Post