coming along nicely james. couldn't you have designed the intake to avoid the hood cutout though?

 

I was going for the best design I could on the intake not for it to clear the hood
I am going to be putting a 2.5" tall cowl scoop over it as the turbo will be protuding through the hood a little also
-James

 

Looking very good!!! I like the finshed intake manifold.

Randy

 

 

looking good anymore updates

 

is that intercooler going to fit behind any part of a stock bumper?

 

its angled

 

Lots of updates coming monday
Cage will be finished
Geforce pro 5 point harness installed
dash installed
battery mounted in front of passanger tire
buddy club race seats installed

next weekend I will:
weld on flange to new 90mm accufab throttle body
weld up charge pipes on cold side
pull out gas tank and sump
build the mounts for the new rear end

week after I will be installing tranny/trq converter
install the huge moroso oil cooler for tranny
install nice b&m shifter
drop the car off to get the drive shaft made

-James

 

Nice cant wait i take it that you are doing all Vbands then, what kind Wiggins perhaps

 

I've got that same setup with the buddy club and g-force 5pt. You must be a skinny guy to fit in the seat.