Car boggs-cel code 13
#1
Car boggs-cel code 13
after I put my stock injectors back in (had 450's) and took the resistors out, pulled the jumper J1. as soon as I started it back up i got the cel, code 13.BARO Sensor (Atmospheric Pressure). I took the stock map (P06) and burned it onto a chip and put it in. It ran fine for about 20 mins, then I turned a corner and gave it some gas and got nothing, only would accelerate when i had the throttle pushed to the floor. Now the cel is coming on whether I have J1 connected or not.
I have J12 clipped for datalogging.
I am visiously trying to get EcuControl to work and am about ready to drive my car off a cliff. Any help would be nice.
I have J12 clipped for datalogging.
I am visiously trying to get EcuControl to work and am about ready to drive my car off a cliff. Any help would be nice.
#5
Re: Car boggs-cel code 13
Its not canadian, i can see the baro sensor inside the ecu, i've been running it with j4 pulled (on the stock map) now for a week or so and the cel stopped coming on. also having no problems with car bogging anymore, it just started running normal again. (wierd ---- man)
Thread
Thread Starter
Forum
Replies
Last Post
-SKUM-
Hybrid/Tech
2
05-13-2007 03:17 AM