Car boggs-cel code 13
after I put my stock injectors back in (had 450's) and took the resistors out, pulled the jumper J1. as soon as I started it back up i got the cel, code 13.BARO Sensor (Atmospheric Pressure). I took the stock map (P06) and burned it onto a chip and put it in. It ran fine for about 20 mins, then I turned a corner and gave it some gas and got nothing, only would accelerate when i had the throttle pushed to the floor. Now the cel is coming on whether I have J1 connected or not.
I have J12 clipped for datalogging. I am visiously trying to get EcuControl to work and am about ready to drive my car off a cliff. Any help would be nice. |
Re: Car boggs-cel code 13
check your wiring again. make sure you have the correct plugs plugged into the correct sensors
|
Re: Car boggs-cel code 13
I never unplugged any of the sensors, i'll check it anyway.
|
Re: Car boggs-cel code 13
Baro sensor is internal on the OBD1 ECUs (most of them, not Canadian generally)
So if you have a Canadian ECU, you might need to disable the Baro sensor in Uberdata/Crome |
Re: Car boggs-cel code 13
Its not canadian, i can see the baro sensor inside the ecu, i've been running it with j4 pulled (on the stock map) now for a week or so and the cel stopped coming on. also having no problems with car bogging anymore, it just started running normal again. (wierd ---- man)
|
All times are GMT -5. The time now is 05:34 AM. |
© 2024 MH Sub I, LLC dba Internet Brands