ZC 16 DOHC rebuild kit?
#1
Guest
Posts: n/a
ZC 16 DOHC rebuild kit?
I'm a newb... I recently got a fairly rust free 89 Si. The motor shows 200 Psi on all cylinders..
Long story short I also got a ZC16 DOHC with a spun rod bearing for $50!
I am building the car for the GRM $2008 challenge..
Just wondering where to get a bearing kit for the motor....yes it will bea home made turbo setup. MX6 IHI turbo.
Thanks!
JM
89 Si GUTTED!
Northstar 32 V V8 Fiero
00 TDI Golf
66 Corvair Turbo , Blow through , Intercooled..ect..ect.
Long story short I also got a ZC16 DOHC with a spun rod bearing for $50!
I am building the car for the GRM $2008 challenge..
Just wondering where to get a bearing kit for the motor....yes it will bea home made turbo setup. MX6 IHI turbo.
Thanks!
JM
89 Si GUTTED!
Northstar 32 V V8 Fiero
00 TDI Golf
66 Corvair Turbo , Blow through , Intercooled..ect..ect.
#7
Guest
Posts: n/a
Re: ZC 16 DOHC rebuild kit?
For me it's all about whats cheap and bolts in with ease. I did a fiero with a Northstar V8 converison and I hate wiring with a passion.
What else is good that fits the EF chassis? (good= cheap) I have Koni's coilovers , sparco seat , gutted , ST rear bar , poly bushings. I have $700 in the build thus far and another $1300 to go for engine turbo and wheels... Already got a 1/2 rad too. I want the most HP for the least amount of money.
At one point we were even thinking of putting a Accord V6 drivetrain in the back seat. Too much BS thou
What else is good that fits the EF chassis? (good= cheap) I have Koni's coilovers , sparco seat , gutted , ST rear bar , poly bushings. I have $700 in the build thus far and another $1300 to go for engine turbo and wheels... Already got a 1/2 rad too. I want the most HP for the least amount of money.
At one point we were even thinking of putting a Accord V6 drivetrain in the back seat. Too much BS thou
Thread
Thread Starter
Forum
Replies
Last Post