y8 minime w/graphite hg
#1
y8 minime w/graphite hg
anyone ever used a graphite hg when doing a minime swap.im concerned about using a metal gasket because of not having the block decked.opinions welcome.but i would like to know if anyone has done it,and had problems.thanks.
#3
Re: y8 minime w/graphite hg
im just concerned about how well the metal gasket will seal after having the graphite ---- scraped off.ive replaced graphite with graphite,but not with metal.i guess i will give it a shot.thanks.
#7
Re: y8 minime w/graphite hg
I wouldnt use copper spray with the graphite Hg, just clean the deck real well with a wheezie wheel, or a peice of sand paper attached to a block. It will come clean. Metal HG's are the way to go..
#8
Re: y8 minime w/graphite hg
Originally Posted by AbaZ
I wouldnt use copper spray with the graphite Hg, just clean the deck real well with a wheezie wheel, or a peice of sand paper attached to a block. It will come clean. Metal HG's are the way to go..
+10, oem metal for me
#9
Re: y8 minime w/graphite hg
I normally just use a razor blade and carefully scrape the excess HG material off. Then a bit of acetone to clean the film off. and finally i give it a once over with a Drywall hand sander , cleans up pretty good.
Make sure the sheet is on there nice and tight.
Just sand across the deck until its smooth.
Before.
After. Flat rate deck job.
Make sure the sheet is on there nice and tight.
Just sand across the deck until its smooth.
Before.
After. Flat rate deck job.
Thread
Thread Starter
Forum
Replies
Last Post