Like i said wheredo the thrust washers go on the crank?

also go new jpr piston rings. set of three rings. im assuming the small on goes on top the thick one in the middle and the oil one is on the bottom. i read that the if the rings have any words on them they are to face up. also staggering the gaps, no gaps over the pin
and staggered 120'. is this right?

 

i would also like to know.

bump

 

come on people, doesnt any one have an answer?

 

thrust washers go on each side off the block side of the main bridge. i BELEAVE they are inbetween the #2 and #3 cylinders. they are there to help stop the crank from thrusting (move front to back). they should look like 1/2 a big washers. to install, flip the block over, lay the crank on, then you can install them by insterting one end, and pushing it all the way around the crank. i'll take some pics of mine if that isn't clear (it's about as clear as mud i think).

 

i sat down and looked hard and yes i found the spot. they make the crank snug.thanks

 

np, that's what we're here for.