Obd0-1 conversion question
Thread Starter
0.5 BAR
Joined: Nov 2004
Posts: 166
Obd0-1 conversion question
Today I installed a odb1 computer. The car run good it feels strong. But Im gettinf code 21 spool valve solinoid. Vtec is engageing but I think thats becuase of the vtec controller. I check all the vtec connections between the vtec controller and the new computer everything is connected correctly. Also on the computer it says (vtec s200) I think it was designed for hondata s200. Any info will be helpful. p28 ecu
3.0 BAR
Joined: Feb 2003
Posts: 9,089
Re: Obd0-1 conversion question
1) The ecu wire for Spool solenoid is attached to what?
2) Was the vtec controller in there BEFORE the obd1 ecu? Because the wire from the ecu is possibly not hooked up to the vtec spool solenoid because the controller does al the work.
2) Was the vtec controller in there BEFORE the obd1 ecu? Because the wire from the ecu is possibly not hooked up to the vtec spool solenoid because the controller does al the work.
Thread Starter
0.5 BAR
Joined: Nov 2004
Posts: 166
Re: Obd0-1 conversion question
Originally Posted by crx88Si
1) The ecu wire for Spool solenoid is attached to what?
2) Was the vtec controller in there BEFORE the obd1 ecu? Because the wire from the ecu is possibly not hooked up to the vtec spool solenoid because the controller does al the work.
2) Was the vtec controller in there BEFORE the obd1 ecu? Because the wire from the ecu is possibly not hooked up to the vtec spool solenoid because the controller does al the work.
Thread
Thread Starter
Forum
Replies
Last Post
AFAccord
Engine Management
4
Jun 15, 2007 03:32 AM
bipedbear
Hybrid/Tech
7
Nov 10, 2004 02:47 PM
