B16CRXT

wait, I thought you said you were using a PM6?

b16crex

i am using a pm6, its chipped for turbo edit with the pr3 stock rom... recurved for 450 injectors the car will idle for a second then shut off. and it doesn't like to rev much...

projekteg

try using the pr4 map and see what that does. also, since you don't have your down pipe on the header, is your o2 sensor not getting a reading, or is it in the stock location near the top of the header?

b16crex

for your info, there is something wrong with the zdyne, when i sent it to zdyne the first time they had to fix a few things on the ecu and it still does not work and hasn't from the start. The people at zdyne don't know what is wrong with the ecu either.

b16crex

projekteg, i will try out a pr4 basemap... and let you know the results. the o2 is located on the lower section of the 2-peice header and is wired. I have to check if it is recieving current.

b16crex

pr4 basemap was a no go. The pr3 acted better

b16crex

fawk it!!!! i give up.

crx304

for one, the rom is prolly too lean. on startup, the injectors are dumping more fuel than @ idle. so scale it up 5% at first across the board.

secondly, check and see if the launch control is activated @ 4000 rpm on the basemap (it will disengage @ 8mph) i think that it is, so edit it and make it like 6000rpm, or disengage it completly

hope this helps
mike