90turbohatch

I know its easy to get out with a roll pin punch, but I don't have one and I can't get the ------ think out. How do you guys get it out? I'm talkin about the roll pin that holds the shift linkage to the tranny on an ef civic.

beerbongskickass

Just use anything that will fit in there and a hammer...

Spenser

get a little Bit from your drill gun (like a torx or something) put it in the pin and hit it with a hammer.

Dr.Boost

Find a bolt that fits inside it. Screw drivers don't work. If the punch is the wrong size it also won;t work. That ------- pin has teeth on it(seriously). I hate that ******. I usually drag the motor out with the linkage hooked up so I can get a better swing at it(assuming you're swapping a motor/tranny).
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

tranceminister

Oh yeah.. The bitch pin. I used a bolt or nail or something to remove it on my buddies tranny. It came out pretty easy though if you find something to knock it out.

Honda16hb

my motor came out with that son of a bitch still attached and it still has that son of a bitch attached. onyx told me that the bolt from the ac compressor is the perfect fit since it's end is tapered to the right size.

90turbohatch

Thats what I did last time, but I'd like to just get it out first if I can. I know it comes out like butter with the proper roll pin punch cause that what I used once I found someone who owned on and the motor and trans was already out of the car. I guess i'll try a bolt or torx.
Thanks fellas

biggmike

I sold my CRX to Researcher and helped him change the clutch and we had to drop the linkage with the tranny then the bitch didnt wanna go all the way in. My grandfather just loves me when i use all his drill bits as punches.

Reddy

don't forget to talk dirty to it