I found it!
#11
Re: I found it!
weel i tell you you what. i hooked up the z6 head and everything looks good. i have two small problems. one i need the 5 posts that go on the head to hold the valve cover on. those ill pick up tomorrow. second on the block next to the thermostat there are two watrer outlets where do they go?
and also i got the bottom right distributor bolt on to hold with a washer. how do the rest get on. thanks guys . im close i can feel it.
and also what is the cheapest route to get the vtec up and running. $125 for a chipped p28 is steep. anythingt else?
and also i got the bottom right distributor bolt on to hold with a washer. how do the rest get on. thanks guys . im close i can feel it.
and also what is the cheapest route to get the vtec up and running. $125 for a chipped p28 is steep. anythingt else?
#14
Re: I found it!
ok i think there is some confusion here.
if you use a PM6 use a d16a6 distributor!
if you use a p28 (or any other obd-1 ecu) use a d16z6 distributor (on z6 head),
if you're installing a complete z6 motor your best bet to get it running smoothly and properly is a p28.
I was confused and it looked like he was going to use a a6 dist on a p28!
if you use a PM6 use a d16a6 distributor!
if you use a p28 (or any other obd-1 ecu) use a d16z6 distributor (on z6 head),
if you're installing a complete z6 motor your best bet to get it running smoothly and properly is a p28.
I was confused and it looked like he was going to use a a6 dist on a p28!
Thread
Thread Starter
Forum
Replies
Last Post