I found it!
My head is all fucked up! So i have a z6 head that turns over great. My question is can i use my a6 dizzy and a6 intake manifold. and since the whole z6 engine is going in to a 90 crx dx i need to get a p28(chipped?) and a vtec hack. is there anything else. wahts my best cheapest way. thanks
|
Re: I found it!
i can chipn the pm6 right
|
Re: I found it!
90 and up PM6's are best for chipping as older ones are complicated.Im pretty sure the A6 dizzy is a no go with OBD1.
|
Re: I found it!
Originally Posted by 90dx
90 and up PM6's are best for chipping as older ones are complicated.Im pretty sure the A6 dizzy is a no go with OBD1.
|
Re: I found it!
so i can use my pm6 ecu and distributor and intake manifold????
|
Re: I found it!
yup. d16a6 dist must be modified on the mounting holes aka notched and washers used to sit flush against the head. only 2 bolts will line up even after this mod.
|
Re: I found it!
sweet thanks. now for my next question? can i install the head today and run the engine with out the vtec hooked up. i can right?
|
Re: I found it!
sure can
|
Re: I found it!
You can also use a rpm switch to activate the VTEC for the mean time until you get a ecu chipped and vtec activation setup.
|
Re: I found it!
Originally Posted by d16y7nh
sweet thanks. now for my next question? can i install the head today and run the engine with out the vtec hooked up. i can right?
|
All times are GMT -5. The time now is 07:31 AM. |
© 2024 MH Sub I, LLC dba Internet Brands