My head is all fucked up! So i have a z6 head that turns over great. My question is can i use my a6 dizzy and a6 intake manifold. and since the whole z6 engine is going in to a 90 crx dx i need to get a p28(chipped?) and a vtec hack. is there anything else. wahts my best cheapest way. thanks

 

i can chipn the pm6 right

 

90 and up PM6's are best for chipping as older ones are complicated.Im pretty sure the A6 dizzy is a no go with OBD1.

 

If you convert to obd1 you need an obd1 dist

 

so i can use my pm6 ecu and distributor and intake manifold?

 

yup. d16a6 dist must be modified on the mounting holes aka notched and washers used to sit flush against the head. only 2 bolts will line up even after this mod.

 

sweet thanks. now for my next question? can i install the head today and run the engine with out the vtec hooked up. i can right?

 

sure can

 

You can also use a rpm switch to activate the VTEC for the mean time until you get a ecu chipped and vtec activation setup.

 

YUp thats fine but it will be a little weak up top without vtecahhh