crank pulley...
#1
crank pulley...
how do you take the crank pulley off? its on a d15b2 if that makes a difference, is there some special trick im suppose to do cause when i put a wrench on the nut it just spins it, i know im doing something wrong...any suggesstions
#6
Re:crank pulley...
Jordan strap a chain wrech around the crank pulley(with a piece of rubber under so you dont mar it up)to hold it, then put your socket on and use a long ratchet and hit it with hard shots from a hammer. You have to shock it loose.
#7
Re:crank pulley...
So if the flywheel isnt on I'm assuming the engine isnt in the car then right? Well if you dont have a flywheel, do you atleast have 2 or 3 flywheel bolts? they are special thread but just screw them in a little ways then get a long pry bar and slide in between the bolts. Basically so the engine doesnt rotate around when your trying to bust the crank pulley bolt free. Otherwise you will need a 1/2 impact gun. Electric ones suck *****, definatly need a decent air compressor and impact gun.
#10
Guest
Posts: n/a
Re:crank pulley...
first time had my friends impact gun on it 2mins straight with no budging, i then went up to my ex's dads tranny shop were i had access to a "good" impact gun and tank and it poped off after about 10 seconds, they are tough buggers
my friend with a saturn he put a wrench and a breaker bar on his and wedged it with the frame and cranked the car up, it was kinda funny, i thought for sure either the wrench would break or the starter would start chunkin teeth
my friend with a saturn he put a wrench and a breaker bar on his and wedged it with the frame and cranked the car up, it was kinda funny, i thought for sure either the wrench would break or the starter would start chunkin teeth
Thread
Thread Starter
Forum
Replies
Last Post
soontobeDA
Turbo Parts For Sale
4
02-09-2009 12:09 AM
Turblow
Hybrid/Tech
27
05-04-2006 10:51 PM
turbohf
Turbo Parts For Sale
0
12-21-2005 01:48 AM
onebadjdmeg6
Turbo Parts For Sale
0
01-07-2005 11:44 PM
turboboy
Turbo Parts For Sale
10
11-21-2003 12:21 PM