crank pulley...
 

how do you take the crank pulley off? its on a d15b2 if that makes a difference, is there some special trick im suppose to do cause when i put a wrench on the nut it just spins it, i know im doing something wrong...any suggesstions

Re:crank pulley...
 

impact hammer

Re:crank pulley...
 

what if you dont have one? does it just need to be like held in place then so the bolt can be cracked loose?

Re:crank pulley...
 

rent one

u need it for like 2 seconds

if the engine is outta the car and the flywheel is still on u can tell ur buddy to hold it while u crank :-\

Re:crank pulley...
 

well im ---- out of luck cause the fly wheel isnt on,

Re:crank pulley...
 

Jordan strap a chain wrech around the crank pulley(with a piece of rubber under so you dont mar it up)to hold it, then put your socket on and use a long ratchet and hit it with hard shots from a hammer. You have to shock it loose.

Re:crank pulley...
 

So if the flywheel isnt on I'm assuming the engine isnt in the car then right? Well if you dont have a flywheel, do you atleast have 2 or 3 flywheel bolts? they are special thread but just screw them in a little ways then get a long pry bar and slide in between the bolts. Basically so the engine doesnt rotate around when your trying to bust the crank pulley bolt free. Otherwise you will need a 1/2 impact gun. Electric ones suck balls, definatly need a decent air compressor and impact gun.

Re:crank pulley...
 

yea the motors on a stand...im gonna try that. thanks jeff

Re:crank pulley...
 

Good luck Jordan hope you bust the nut :P I even had trouble breaking my crank pulley bolt loose with an Impact gun. It took a while for it to finally loosen.

Re:crank pulley...
 

first time had my friends impact gun on it 2mins straight with no budging, i then went up to my ex's dads tranny shop were i had access to a "good" impact gun and tank and it poped off after about 10 seconds, they are tough buggers

my friend with a saturn he put a wrench and a breaker bar on his and wedged it with the frame and cranked the car up, it was kinda funny, i thought for sure either the wrench would break or the starter would start chunkin teeth