The car is an 88 Crx si, d16a6 motor fully built, running dsm 450's and turboedit and a 2.5 bar map sensor. I snapped my timing belt so I swapped the motor today for another built a6.

No changes were made anywhere, straight swap. Got it all back together, go to start the car and the fuel pump primes, try and start the car and it dont work, crank and crank and cranks, throws a few little exhaust blips.

Turn it down and try again, CEL on dash is now kinda flickering, slows down and then flicker faster, I check the ecu code, cant read it, damn thing it changing speeds on its flashes, sometimes rapid, sometimes slow, but it would pause at points.

I check the motor, everything seems mint, look harder........

BROKE THE MAP SENSOR

Little itty bity 2.5bar has these little prongs and everyone of them broke out, 3 of them. ****!

Cant do anything.

My question is, nothing was changed in the swap, other than breaking the map sensor, but would it cause the motor to do the things that I am describing?

Or is something else the matter?

Hope someone can help

Thanks

 

maybe you've got a bad main relay or ecu.

 

spark? timing? compression? even though the pump is priming are you getting fuel?

try known good ecu.

 

its your vtec