Beefing up a d15 block
Guest
Posts: n/a
Re:Beefing up a d15 block
I'd say for beefing it up would be to fill the cylinders with concrete and toss it into the lake, no but really you can't even use 1.6 rods to work unless you get them machined and then get it bored out for any 1.6 pistons to work. Too much for too less. Go find a 1.6 dx block or si block, since you should be able to buy them for all the change in your couch cushions from leftover swap.
1.5 BAR
Joined: May 2003
Posts: 808
Re:Beefing up a d15 block
true true go on bay u can find d16y7's with low miles, i got mine shiped for 250 look for a "big" provin junk yard that is a business selling on ebay(less chance of getting ripped off 
) and it came with a 6 month warrenty
) and it came with a 6 month warrenty
1.5 BAR
Joined: Mar 2003
Posts: 694
Re:Beefing up a d15 block
OK I'D USE SRP FOGED PISTONS,EAGLE RODS,GET THE BLOCK SLEEVED AND A GOOD PORT AND POLISH AND A SET OF CRANE CAMS
I'D USE A T3/T4 TURBO AND A CUSTOM MANIFOLD RUN A NICE AMOUNT OF BOOST MAKE SURE YOU HAVE MPFI ON THE ENGINE AND I TUNE IT WITH GETTODYNE ON A SI ECU
I'D USE A T3/T4 TURBO AND A CUSTOM MANIFOLD RUN A NICE AMOUNT OF BOOST MAKE SURE YOU HAVE MPFI ON THE ENGINE AND I TUNE IT WITH GETTODYNE ON A SI ECU
Thread
Thread Starter
Forum
Replies
Last Post
