Axle help ASAP
#1
Axle help ASAP
I have a 91' Civic HB with a B16 in it/ I'm using a YS-1 trans. The passenger side axle does not sit all the way in and seems to almost pop out and it's LEAKing really bad. I'm using 90'-93' inetgra axles and I removed the spacer and dust sheilds from the inner hub Why is this not fitting right. What do I have to do or what axle do I have to use. The driver side with the intermediate shaft sits fine it's the other side. I need help ASAP> Thanks.
#2
Re:Axle help ASAP
check the little snap ring at the end of the axle make sure its still looks good i allways have to tap my axles in make sure they snap in or yea you will have fluid everywhere but the snap ring is the only thing i can think of that will do that
#6
Re:Axle help ASAP
Thanks Shadow.. Yea Luckly when I got my motor . trans it still had the inner joint from the JDM axle I compared the two and it turns out the JDM one was like a 1/4 of a inch shorter barely noticeable unless you looked hard. So I just took the inner joint from the JDM and put it in the integra axle I had and it works fine for now. Now lets see what will be next.
Thread
Thread Starter
Forum
Replies
Last Post
hotrex
General Discussion
1
09-29-2003 01:43 PM