QikEnuF

What were the build clearances?

And widebody93, don't make me find your GF's phone number...

ryan89crx

is Kaizen going to help you pick up part of the tab on this? or is it all on you? they seem like pretty decent guys...

bigdaddyvtec

Reid is hooking me up with a deal on the rebuild. Pistons, Im fucked... Gonna be around a G for the re build (bore + hone + new CPs (definately wont be going Endyn again... they didnt even want to hear it-talked to Larry) rings, pins, locks- re-check tolerances and glue it back together...... im pissed, but what can I do ya know Sure wish Endyn would stand behind their pistons with me.... Block was machined to THEIR SPEC......


Goal is to have it slicked up and ready for BOTI

RotaryGeek

sucks to hear man, really bad *** build. Best one on here in a while. but you know what they say, bigger they are the harder they fall. Just be glad its only a g to rebuild and you have a dd till you can make that much. It will come back better than before though.

bigdaddyvtec

Oh it aint dead my nig... If I would have known this is whats going on rest assured the controller would have been cranked anyways!!!

For all the ---- I flick people I expect some back, and consider the source.. Acclude cant afford to stock his house with toilet paper let alone build ----, so via proxy of pitty, i dont care much about what he has to say... But Im not knocking him cause hes broke... Simply for the fasct that hes a ****** coon. Anyways... rest assured I wont let you down, hoping to have it all back together by BOTI here in the Seattle area... The Maroon 4-door brigade will be there!!!!

bigdaddyvtec

Hey: ---- you buddy.... I dont have roids....

hondaunlimited

---- that, i use 40 grit on my roids.....

but hey, best of luck on your build, dude. once you get it u and running, im gonna want to check it out. i wouldn't mind driving across the state t do so. i wanna see what real horsepower is, lol

gen4acclude

dude your nose is brown from being in brian's *** but you then you show respect in the same post, ------ classy, like that lol what you think bigdaddy

bigdaddyvtec

So ya updates for all you less than white ----------ers!!!! LOL.

Blocks at the machinist's getting a fresh bore and hone too... Block measured out, as did the crank.... So should be putting the motor back together in a week or so, and getting it in the car in the next 2-3 weeks. Possibly sooner as I have a bunch of time off (paid...lol) to focus on gitten her done.. So the bottom end is getting a new set of 88mm CPs a once over on tolerances, and then getting glued back together. Once I aquire a twin disk (Thanks Mike!!!) we'll get her back on the road... As long as I get it done in July ill be happy... I dont foresee any problems.... Then again... I didnt expect this onr to get fucked up either. ---- happens. Hopefully the difficult part is over with and I can go get kicked off the track for not having a cage. Carb has yet to make a pass at the track with the new setup. Weathers been good lately... I pulled the 5 pound spring out of my wastegate so that i can putt around during the week at like 400 whp, and then crank the mbc to 20 for the **** at the streetraces on the weekends....

Then for the track fiill er up with the 119 and go straight for the nigstrodomus setting.... Sure be cool to pull a low 11 sec timeslip out the 4 door...

LOL

MR Lee, get readey... again. LOL...


CANT ------- WAIT.



Stay tuned nigs. We got another trick up our sleeve too....