JDAVIS, check my attempt @ alky calculations!
#1
JDAVIS, check my attempt @ alky calculations!
Ok, so i read and reread some of your old posts and this is what i could come up with...
What ive done is taken about 20% fuel out of my original pre alky injection map (450cc injectors).
I'm currently using a 330cc (roughly 22% of 85% ID w/DSM 450cc) spray nozzle w/ sureflow 150psi pump + progressive controler
I think i'm going about this ***-backwards but O'well... my car runs great the way it sits and i don't want to touch the fuel.
'figure that alky is 2 parts to 1 part gasoline'
330cc/3= 110cc **this is probably wrong**
alky=2 x 110= 220cc --------- 220/330= 66% alky
h20= 1 x 110=110cc --------- 110/330= 34% h20
or do i figure...
4x450cc= 1800
.85 x 1800= 1530cc
1530 x 11% (half of 22% with 50/50 mix)= 168.3cc
.......................................... ----... i don't know what i'm doing now
give me your thoughts...
What ive done is taken about 20% fuel out of my original pre alky injection map (450cc injectors).
I'm currently using a 330cc (roughly 22% of 85% ID w/DSM 450cc) spray nozzle w/ sureflow 150psi pump + progressive controler
I think i'm going about this ***-backwards but O'well... my car runs great the way it sits and i don't want to touch the fuel.
'figure that alky is 2 parts to 1 part gasoline'
330cc/3= 110cc **this is probably wrong**
alky=2 x 110= 220cc --------- 220/330= 66% alky
h20= 1 x 110=110cc --------- 110/330= 34% h20
or do i figure...
4x450cc= 1800
.85 x 1800= 1530cc
1530 x 11% (half of 22% with 50/50 mix)= 168.3cc
.......................................... ----... i don't know what i'm doing now
give me your thoughts...
#5
Re: JDAVIS, check my attempt @ alky calculations!
thanks!
I'm using a PLX m300 at the moment but in about 2 weeks i'm gonna order up the AEM wideband/lambda gauge. Everytime i mash the gas the ------ PLX goes flying, its pissing me off... Ive been wanting to get something i can actually mount... the Lambda display should be more precise when ------- with alky/h20 eh??
I'm using a PLX m300 at the moment but in about 2 weeks i'm gonna order up the AEM wideband/lambda gauge. Everytime i mash the gas the ------ PLX goes flying, its pissing me off... Ive been wanting to get something i can actually mount... the Lambda display should be more precise when ------- with alky/h20 eh??
Thread
Thread Starter
Forum
Replies
Last Post
TunerToys
Hybrid/Tech
31
08-31-2009 10:54 AM
accordepicenter
General Discussion
9
05-07-2006 01:39 PM