Where can i get sleeves done?
#11
Re:Where can i get sleeves done?
dude, for 7 psi, you don't have to do ----! and later on when you feel like spending some more money, get some pistons and rods, and raise to boost to 10psi (maybe more, i'm not sure exactly how weak h22 sleeves are), and if you want to run more than that, get it sleeved down the road. for 7 psi, you can run it stock safely.
#13
Guest
Posts: n/a
Re:Where can i get sleeves done?
Originally Posted by Elite CRX
If your only going to run 7 psi you dont need sleeving, it will be a waste of money. Get some pistons and rods, then turn up the boost to lets say 10 psi with a hack and you will be ok. Also get some good injectors like some RC maybe some 390cc.
the stock h22 injector is like a 345....... remember its a 2.2 litr.... you need bigger then 450's i would suggest if you want to run anything over 10 pounds...
h22 sleaves are SUPER weak.. but i have seen stock sleaves handle 10 -12 pounds with JE 9:1 compression pistons.. not stock pistons no way i would run any boost with the stocks.
#14
Re:Where can i get sleeves done?
you pretty much HAVE to resleeve the block on H series motors to run forged pistons because the stock sleeves are FRM fiber and you cant run them with forged pistons, unless they're coated like wiseco's or something but i dont know anybody that actually has tried these
#15
Re:Where can i get sleeves done?
Thanks for all the info! Its a lose lose situation. If i dont do the pistons the rings go. If i do the pistons the sleeves go. If i do them both im deep in my pockets! I think im going to do 7 psi with a t3 Dsm injectors and a SAFC2 ---- it. if she blows, she blows. H22's are pissing me off what DOHC motor cant take 7 pounds? a damn cavalier can do more than that. I'll let ya'll know how it goes
Thread
Thread Starter
Forum
Replies
Last Post