Is there a certian company that will resleeve my h22 so it can handle boost? and what about ringlands. I guess they go under boost to on the h22? Im suprised that a d16 can handle boost but an h22 cannot. i know the d16 has lower compression but Damn! this sucks im starting to get in to some big $$

 

Why dont you get pistons and rods and do the sleeving later on. U already have a semi closed deck .You should be able to boost about 15 w/o sleeving. I would think;

 

rip everything out and ship it to GE or benson.

it doesnt weight much when everythings stripped!

 

how much boost are you planning to boost? 17-20+psi? then it ain't wrth it to sleeve it, if your boosting mildy meaning 6-10psi. I'm sure those h22's can handle that stock. And sleeving cost between 800-1000, theres golden eagle mfg, GE, Benson, Darton, etc,..

 

h22's are weak on boost.

 

i dunno, I figure i'm running 10 psi witht he hack daily on my d15b7, I didn't know those h22's were that weak..makin me think twice about an h22 swap in the future..

 

It sucks alls i want to do is run 7 psi on my motor and everyone says the ringlands and the sleeves are weak. I didnt want to get this deep in money to run 7 pounds. But when its done the car should be quick.

 

Darton Sleeves

 

If your only going to run 7 psi you dont need sleeving, it will be a waste of money. Get some pistons and rods, then turn up the boost to lets say 10 psi with a hack and you will be ok. Also get some good injectors like some RC maybe some 390cc.

 

390cc?