When 1st time run turboed car, what fuel setting? SMC related
#1
Guest
Posts: n/a
When 1st time run turboed car, what fuel setting? SMC related
Ok so say i got everything done, all oil lines hooked up, all pipes all the injectors are good... and i use a SMC or SMC 500..
what do i set to get it into "safe" mode so i can drive for now to the dyno shop to get it tuned??
what do i set to get it into "safe" mode so i can drive for now to the dyno shop to get it tuned??
#2
Re:When 1st time run turboed car, what fuel setting? SMC related
Pick some of the settings in the "settings post" in the engine management section. If you have an air/fuel gauge then just make sure its in rich till you get to the dyno.
#6
Guest
Posts: n/a
Re:When 1st time run turboed car, what fuel setting? SMC related
Ok -35.. but what i'm worried is, regardless if i tow or not, the dyno operator doesn't know the A/F unless he runs it at WOT on the dyno to redline, so if he does that, doesn't that pose a risk?
Thread
Thread Starter
Forum
Replies
Last Post
2000vsm
Engine Management
0
10-04-2005 12:10 PM
2000vsm
Engine Management
7
07-16-2003 09:28 PM