toga main and rod bearings
#1
toga main and rod bearings
i keep loosing motors to spun bearings and was wondering if these are any better than stock:
http://www.importperformanceparts.ne...ngs_honda.html
lemme know if yall are using these
jman
http://www.importperformanceparts.ne...ngs_honda.html
lemme know if yall are using these
jman
#2
Re:toga main and rod bearings
I'm one of those guys that believes bearings are bearings, and what you should be concerned with are loosening up your clearances for "more than stock" power expectations. That's just me though.
I use federal mogul bearings with .015 clearance on all rod and crank throws. I believe .007-.012 is about what the factory calls for on my motor, although it does vary with the different rod/crank throws in the manual.
I use federal mogul bearings with .015 clearance on all rod and crank throws. I believe .007-.012 is about what the factory calls for on my motor, although it does vary with the different rod/crank throws in the manual.
Thread
Thread Starter
Forum
Replies
Last Post