Fuel controls on a Trailerpark budget
#61
Re:Fuel controls on a Trailerpark budget
I think you can only run more boost if your injectors are bigger..... I'm not sure though. I'm putting the FTB and 450's on my car today!!!!! What did you use for the +12 volt power source?
#65
Re:Fuel controls on a Trailerpark budget
Sweet, Rolla. Keep a paranoid eye on the AF gauge until you get a feel for how it reacts; my very limited understanding of MAF makes me think you have a possibility for leaning out at certain flow levels. Keep us updated, I'm very curious.
Semnos, set the output voltage at 3.0-3.1 volts and go from there. You barely have to turn the trim pot to tune the mixture, so easy does it.
Semnos, set the output voltage at 3.0-3.1 volts and go from there. You barely have to turn the trim pot to tune the mixture, so easy does it.
#66
Re:Fuel controls on a Trailerpark budget
My engine is RIP as of this morning.... I don't think it was the FTB, however, because the air/fuel ratio seemed fine if not rich, but I think I may have just ran too much boost (10 psi) .
LOL @ your last post warning me about blowing my engine....... My motor comes out tomorrow.
LOL @ your last post warning me about blowing my engine....... My motor comes out tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
donalson
Turbo Parts For Sale
35
12-20-2003 11:25 PM