chr1z

ahh if i read this about a minute before ordering a big roll from hamiltonmarine.com, ill try to go with the 1.5 and if it does touch the alternator ill have it banged a tiny bit and heat wrap it, also what do i use 2 hold the wrap just some regulat hose clamps?

samson

Sorry. Uhhhh....yea I guess. Wrap it tight kinda like you would for an ankle wrap. Starting and layering over it, stretching, pulling tight, wraping down on an angle a little further down on the downpipe, repeat. Hose clamps on the ends I guess. I never did it, but it sounds savvy. Good luck and post in General Disscussion when it's done with some numbers. A Hyundai.....HMT has expanded.


JP

chr1z

well this exhaust shop out back of this dudes house was taklin about 300$ sayin that it may take along time to make somethin 2 fit thats nuts

Ichi-Go

I have an Acura Legend and dont have enough room for the dowpipe under the tranny so I am gonna just dump it out in front of the front wheel. Maybe you could do something similar.

chr1z

its that i need my o2 sensors for my car to run correctly

Spenser

can you make the downpipe go over top of the alternator?

chr1z

no clue ill ask the muffler guy tommrowo

IndianRide

Is that manifold off of the scoupe turbo? I have the same engine in my winter beater na scoupe.

chr1z

yea its the turbo scoupe manifold, the scoupes use the same 1.5L alpha motors, the turbo scoupe uses a t15 oil/water cooled around 115 hp at like 5 psi with oil sqirter pistons but the compression sucks .