Charge pipe question
#1
Charge pipe question
I was goin to use a section of rad hose for a flex in the charge pipes. I was goin to use it before the IC inside the engine compartment. Would the hose get too hot and melt even if I wrap with some type of heatshield ?
#2
Re:Charge pipe question
Well, it has been done before, but just make sure you keep it as far away from your manifold and turbo (or any other heat related part) as possible to prevent melting. Why not just pick up some mandrel bends and cut them to fit?
#4
Re:Charge pipe question
the only reason i wana use the hose is for a bit of a flex for when the engine torques. I have some mandrels ready to be installed also. another question is what type connectors are u guys using to connect the madrels to madrels and mandrels to intercooler etc. ?
Thread
Thread Starter
Forum
Replies
Last Post
AzntaggeR
Forced Induction
3
04-12-2005 02:41 AM