question about mating 2.5" charge pipe to 3" charge pipe...(any downsides?)
#1
question about mating 2.5" charge pipe to 3" charge pipe...(any downsides?)
the chargepipe going from my compressor housing all the way through both sides of my JRC 6" intercooler is 2.5", so i ordered an ebay CAI to make my upper chargepipe, but the problem is it comes in 3" (even though it clearly said 2.5" diatmeter on the ebay auction). i'm kind of stuck with it. i guess the quesiton is will i have any type of air flow problems if i mate the 2.5" charge pipe to the 3" charge pipe? i think i may have read somewhere that the volume of air is affected if the same diameter charge pipe is not used throughout the whole charge piping system.
Thread
Thread Starter
Forum
Replies
Last Post
TTC
General Discussion
16
04-22-2007 03:10 PM
70Challenger
Wanted
1
06-22-2006 01:56 AM
idiot-stick
Forced Induction
5
11-14-2005 09:27 PM
robs99si
Forced Induction
15
07-13-2004 02:07 PM