actuator pressure feed
#1
actuator pressure feed
Hi all,
just looking for sum help
can i run a feed of my J pipe befor the T/B and manifold for the actuator on my turbo
Would this help keep boost response accurate, and helps the actuator be bit more precise, so it does not spike and then go back down
Thanks
just looking for sum help
can i run a feed of my J pipe befor the T/B and manifold for the actuator on my turbo
Would this help keep boost response accurate, and helps the actuator be bit more precise, so it does not spike and then go back down
Thanks
#2
Re: actuator pressure feed
Where exactly is the J-pipe? When I think J-pipe-, I think of the pipe coming right off the turbo on say a 16G setup. But yes, you can run your wastegate line off a nipple on the charge piping. I've ran it off the pipe right after the outlet of the turbo before.
#3
Re: actuator pressure feed
Originally Posted by ju-on
Where exactly is the J-pipe? When I think J-pipe-, I think of the pipe coming right off the turbo on say a 16G setup. But yes, you can run your wastegate line off a nipple on the charge piping. I've ran it off the pipe right after the outlet of the turbo before.
Would this be better than running it of a tapped feed on the intake manifold
#4
Re: actuator pressure feed
I don't know what's better or worse. I run mine right off the fitting on the compressor housing now, which is similar to just running it off the pipe. That's pretty much how I've always done it, and it works fine. I have once, Tee'd off the line that went from the manifold to the BOV, but I've heard that isn't the best way. So now I always run it off the charge pipe/compressor.
Thread
Thread Starter
Forum
Replies
Last Post
soontobeDA
Forced Induction
10
12-10-2008 09:48 AM
kKdARIAN
Turbo Parts For Sale
6
05-23-2006 11:55 AM
sunny jay
Wanted
0
07-07-2005 02:35 AM