willems enhanced programmer help
#1
willems enhanced programmer help
i have software 0.97g off the willems site, this thing is barrowed and i cant get it to read or program a chip..
1. do i set the software to willems or pcb3
2.my board doesnt look like anypictures i see on the prgram or pgmfi, so i dont know if im suppsed to change jumpers and if so which ones where
when i test hardware it says present,
when i do chip read it says chip read ok, if i go to save bin then try to open it with uber it gets an error and closes and does the windows error reporting
when i try to erase is happens instantly so im not sure if its actually erasing it or not..
when i load a bin it says bin file loaded ok,
when i click program it starts then goes right to ERROR: Write sector 1, somtimes sector 0
if anyone can point out what im doin wrong id appreciate it meanwhile ill keep trying and reading
1. do i set the software to willems or pcb3
2.my board doesnt look like anypictures i see on the prgram or pgmfi, so i dont know if im suppsed to change jumpers and if so which ones where
when i test hardware it says present,
when i do chip read it says chip read ok, if i go to save bin then try to open it with uber it gets an error and closes and does the windows error reporting
when i try to erase is happens instantly so im not sure if its actually erasing it or not..
when i load a bin it says bin file loaded ok,
when i click program it starts then goes right to ERROR: Write sector 1, somtimes sector 0
if anyone can point out what im doin wrong id appreciate it meanwhile ill keep trying and reading
#2
Re: willems enhanced programmer help
o ya, the chip in it has a known good uberdata bin on it, im just trying to read it, erase it, then program it with a diff one for practice before i do the one im gona put in the ecu
Thread
Thread Starter
Forum
Replies
Last Post
racepak
Engine Management
3
05-17-2006 03:09 PM
ifly87
Engine Management
1
05-01-2006 06:27 PM