PR3 or PW0 basemap on a pm6 or pr4???
#1
PR3 or PW0 basemap on a pm6 or pr4???
I haven't really gotten much into the ecu tuning end much, so i'm still in the dark when it comes to this. Is it at all possible to obtain either the PR3 or PW0 basemap (whichever is better ) and then put them through TE to be used in either a PR4 or a PM6? The reason I'm asking is because i'm picking up a b16a toward the end of the week, but with no ecu. All i have laying around is the pr4 and pm6, and the car is still wired for obd-0. I did obd-1 once on it, but it ended up too many headaches in the end and i sold the p28 i used to have, so cross that answer out. I have a vafc2 wired in and soldered securely into the wiring harness, so vtec engagement is no issue for me, just wondering if i can get the dual tables in on ecu's that were made originally with a single table.
#2
Re: PR3 or PW0 basemap on a pm6 or pr4???
no PR3 code has two maps (low cam and high cam). the TurboEdit PM6 code only has single maps...if you want to use it you have to splice together the two maps manually and then activate VTEC through the A/C relay wire (1 wire setup)
doing a VTEC setup with a PM6/PR4 is not ideal in my opinion
doing a VTEC setup with a PM6/PR4 is not ideal in my opinion
Thread
Thread Starter
Forum
Replies
Last Post
Tell Me Turbo
Engine Management
2
06-18-2004 02:41 AM
turbohf
Engine Management
16
06-14-2004 02:52 AM
TellMeTurbo
Hybrid/Tech
3
12-26-2002 07:42 PM