Please help! Can't get datalogging to work. Tried everything...?
#1
Please help! Can't get datalogging to work. Tried everything...?
I have a chipped P06->P28. I'm running it on a D16Y8 with an Ostrich and Nokia Data Cable with Crome. I can get my cable to loopback with RX and TX tied. I've tried running Cui's 1.5 Quick DL + RTP and Calvin's DTL5 with J12 on and off. I've tried running posted basemaps and new clean maps in Crome. When I do a Sanity check it always says can't find Cui's code.
I got my Chipped ECU from a reliable source so I'm thinking/hoping it's not the hardware. I know my Ostrich is working b/c i removed all fuel and the car wouldn't start, so it is emulating right.
I saw someone mention driving around while running Hyperterminal and pressing space, but I don't trust these maps well enough to drive around.
Can anyone think of something that I haven't tried?
Can someone post a bin known to datalog that I can try?
Or, If i post my bin, can someone check and see if it logs so I can figure out if it's my hardware?
P.S. I also tried ECUControl and Cuddle and I get the same results.
I got my Chipped ECU from a reliable source so I'm thinking/hoping it's not the hardware. I know my Ostrich is working b/c i removed all fuel and the car wouldn't start, so it is emulating right.
I saw someone mention driving around while running Hyperterminal and pressing space, but I don't trust these maps well enough to drive around.
Can anyone think of something that I haven't tried?
Can someone post a bin known to datalog that I can try?
Or, If i post my bin, can someone check and see if it logs so I can figure out if it's my hardware?
P.S. I also tried ECUControl and Cuddle and I get the same results.
#3
Re: Please help! Can't get datalogging to work. Tried everything...?
Originally Posted by dirtygsr94
so is the problem that it wont datalog or your maps dont run .
#5
Re: Please help! Can't get datalogging to work. Tried everything...?
Originally Posted by ****
chances that its your bin are slim to none, chances are its in your settings or your cable/drivers aren't properly installed.
I saw something that looked like the Rx and Tx may be shorting, I'm gonna try to check it out to make sure so I can rule that out.
If you can think of something else, LMK. I really wanna get this working.
Thread
Thread Starter
Forum
Replies
Last Post
chiman72
Engine Management
4
05-17-2006 01:32 AM
vani11aic3
Forced Induction
16
03-29-2006 08:42 PM