sohcpwr

So round 2 of datalogging didnt work too well either. Heres my new list of everything thats done:

2 different ecu's

crome pro and ecu control- I had ecu controld downloaded but never used it so it could have been setup wrong or something. Does it need j12 cut?

j12 IS now cut

purchased xenocrons datalogging cable instead of the nokia (which was probably working anyway!)

correct drivers from the website

when i open port settings under the cable, it says its on com 5, so its set to com 5 in crome.

checksum has been removed and datalogging has been added to the rom

What else could i be forgetting? I just wired in my LC-1 (awesome) and cant even use it!

JonDouglas

Did you make sure all the port settings were the same in Devuce Manager and in Crome Pro? I use Freelog cause I'm a broke bitch so I don't have any hands on experience with Crome Pro but I know you can st the baud rate and parity in Freelog.

sohcpwr

it has baud rate and all, but it is setup according to the wiki on pgmfi.org

Tom-Guy

You coming to xeno's this weekend? Bring your ----, I'll give it a ten minute Kentucky Windage and get you going.

sohcpwr

i dont know if i'll have time to make it up there.. i have to finish headgaskets on a piece of ---- legend (------- v6) and probably take the dirtbike out since i didnt last weekend. I might try to make it up there, what are you guys working on this weekend?

Tom-Guy

We're working on the car, duh.


No, seriously, it should run and have a cage by Sunday.

sohcpwr

run? The engines built already?

Tom-Guy

I expect xeno to have the short block ready when I roll up with the head studs. The head has been pimpjuice for some time now...

This is all bolt-together ----, no brainer, we can whale through it.

sohcpwr

thats sweet. I'll try and get up there this weekend, but no promises. Do you have any thoughts on what it might be?

Tom-Guy

Yes. It is a stupid ------- quirk that needs an experienced hand to beat on it for thirty minutes.