my datalogging port and cable
#1
my datalogging port and cable
well, i really got the idea from stan so that i wouldn't have to leave the cable in all the time. this was my first time soldering on an ecu, so i was a litte scared, but all in all, it turned out nice (now i just hope it works, i haven't had access to a lap top yet :P)
cn2 desoldered
the smallest connector's i could find were 9 pin
female plug soldered in to ecu
didn't have a dremel, but an angle grinder works fine
didn't have any little screws. it's a pretty snug fit and doesn't move without them, but i'll throw some in there sooner or later.
i had to drive an hour to get my nokia cable after running to all the shacks around town. they had three left, i should have bought all of them, but i had a brain fart and didn't think about it until i was half way home :P the cable is pretty short, so i soldered in some pretty long extensions and taped her up
i bought this p05 with the vtec conversion already done, i had never taken it out of the shell completely, but this is what i found, i assume this is the vtec conversion.
cn2 desoldered
the smallest connector's i could find were 9 pin
female plug soldered in to ecu
didn't have a dremel, but an angle grinder works fine
didn't have any little screws. it's a pretty snug fit and doesn't move without them, but i'll throw some in there sooner or later.
i had to drive an hour to get my nokia cable after running to all the shacks around town. they had three left, i should have bought all of them, but i had a brain fart and didn't think about it until i was half way home :P the cable is pretty short, so i soldered in some pretty long extensions and taped her up
i bought this p05 with the vtec conversion already done, i had never taken it out of the shell completely, but this is what i found, i assume this is the vtec conversion.
#6
Re:my datalogging port and cable
Originally Posted by Ravage70
how do u know which wires go where on the ecu and the bable itself
Thread
Thread Starter
Forum
Replies
Last Post
hamburgler
Engine Management
2
07-22-2007 08:26 PM
hondacivicsir1
Turbo Parts For Sale
16
04-02-2007 09:39 PM
Civicvtec23
Turbo Parts For Sale
9
08-11-2006 04:28 PM