HomemadeTurbo - DIY Turbo Forum - my datalogging port and cable

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- Engine Management (https://www.homemadeturbo.com/engine-management-10/)

- - my datalogging port and cable (https://www.homemadeturbo.com/engine-management-10/my-datalogging-port-cable-26741/)

my datalogging port and cable

well, i really got the idea from stan so that i wouldn't have to leave the cable in all the time. this was my first time soldering on an ecu, so i was a litte scared, but all in all, it turned out nice (now i just hope it works, i haven't had access to a lap top yet :P)

cn2 desoldered
http://www.newbieforces.com/files/DL1.jpg

the smallest connector's i could find were 9 pin
http://www.newbieforces.com/files/DL2.jpg

female plug soldered in to ecu
http://www.newbieforces.com/files/DL3.jpg

didn't have a dremel, but an angle grinder works fine ;)
http://www.newbieforces.com/files/DL4.jpg

http://www.newbieforces.com/files/DL5.jpg

didn't have any little screws. it's a pretty snug fit and doesn't move without them, but i'll throw some in there sooner or later.
http://www.newbieforces.com/files/DL6.jpg

i had to drive an hour to get my nokia cable after running to all the shacks around town. they had three left, i should have bought all of them, but i had a brain fart and didn't think about it until i was half way home :P the cable is pretty short, so i soldered in some pretty long extensions and taped her up ;D
http://www.newbieforces.com/files/DL7.jpg

i bought this p05 with the vtec conversion already done, i had never taken it out of the shell completely, but this is what i found, i assume this is the vtec conversion.
http://www.newbieforces.com/files/DL8.jpg