Just started my crx with SAFC connected...
#1
Just started my crx with SAFC connected...
...and i had a check engine light
has anyone else experienced this? it is showing as a faulty MAP sensor?
Car has standard fuel pump, standard injectors, turbo hooked up but no PSI, and all SAFC fuel settings set to 0% or no change....any advice would be great!
thanks
has anyone else experienced this? it is showing as a faulty MAP sensor?
Car has standard fuel pump, standard injectors, turbo hooked up but no PSI, and all SAFC fuel settings set to 0% or no change....any advice would be great!
thanks
#2
Re:Just started my crx with SAFC connected...
go to etc. then to sensor type then select "pressure" and set it at 06 in and 06 out, set the other sensors at 0in and 0 out. i had the same problem and that's what it was. also, while you're in "etc.", make sure you have it set for 4 cyl. and your throttle is set where the arrow is facing upper righ(diagonal arrow), you may already know all of this, but if not, i hope it helped.
#3
Re:Just started my crx with SAFC connected...
surely the other sensors will be set to 0 by default? I have selected pressure sensor and have it as 6 in and 6 out. Could there be any other reasons why i have this light? leak in my charge piping prehaps?
thanks dude
thanks dude
#4
Re:Just started my crx with SAFC connected...
Originally Posted by djnikko
surely the other sensors will be set to 0 by default? I have selected pressure sensor and have it as 6 in and 6 out. Could there be any other reasons why i have this light? leak in my charge piping prehaps?
thanks dude
thanks dude
#5
Re:Just started my crx with SAFC connected...
have it set to 0% change as i have my standard injectors still. i'll crank her over when i get home and let you know the results. I will check that wire into my ECU but pretty sure it is all good....
thanks for the pointers...
thanks for the pointers...
Thread
Thread Starter
Forum
Replies
Last Post
NNBD
Hybrid/Tech
4
09-18-2005 11:20 AM