I dunno whats wrong.
3.0 BAR
Joined: May 2004
Posts: 5,032
Re: I dunno whats wrong.
The AT29C256 will automatically address itself with the flashburn program I beleive.
When you burn a chip do this.
erase
blank check
load file to buffer
program chip
verify chip with buffer
If all that comes out okay, then you are applying the image correctly. That however tells you nothing about the file. Try burning another .bin on there and see if you get the solid CEL. You don't have to turn the car on, just to the run position on the ignition.
odds of a bad solder job are low, odds of a bad chip are also low.
When you burn a chip do this.
erase
blank check
load file to buffer
program chip
verify chip with buffer
If all that comes out okay, then you are applying the image correctly. That however tells you nothing about the file. Try burning another .bin on there and see if you get the solid CEL. You don't have to turn the car on, just to the run position on the ignition.
odds of a bad solder job are low, odds of a bad chip are also low.
Thread Starter
1.5 BAR
Joined: Oct 2004
Posts: 904
Re: I dunno whats wrong.
Originally Posted by Cray91
The AT29C256 will automatically address itself with the flashburn program I beleive.
When you burn a chip do this.
erase
blank check
load file to buffer
program chip
verify chip with buffer
If all that comes out okay, then you are applying the image correctly. That however tells you nothing about the file. Try burning another .bin on there and see if you get the solid CEL. You don't have to turn the car on, just to the run position on the ignition.
odds of a bad solder job are low, odds of a bad chip are also low.
When you burn a chip do this.
erase
blank check
load file to buffer
program chip
verify chip with buffer
If all that comes out okay, then you are applying the image correctly. That however tells you nothing about the file. Try burning another .bin on there and see if you get the solid CEL. You don't have to turn the car on, just to the run position on the ignition.
odds of a bad solder job are low, odds of a bad chip are also low.
0.0 BAR
Joined: May 2005
Posts: 0
Re: I dunno whats wrong.
It may been uploaded fine and all the bytes are fine, but that doesn't check for validity of the bin, only the ecu is going to do that, by giving you a solid check engine light because the program doesn't run correctly.
Thread
Thread Starter
Forum
Replies
Last Post
2000vsm
Forced Induction
10
Jul 7, 2003 11:39 AM
