B16aJunkY

For the past few days i have been buring a chip and trying to make my cars idle not jump.

Spec's:

b16a in 91 dx
basic add ons fuel rail intank headers.

Po6 ecu chiped with a GSR burn.

so far i have the cold warm and moving idle speed at 1 and it still idles around 1.5K and the idle jumps. the IAVC i'v gone from -1 to 5 and it stil dose it. but very slightly. Could there be anything else wrong with the car/wireing? i also have knock sensor unchecked. injctor test disable,closed loop disable and VTP disable all unchecked. please help me on this!!

edit: using uberdata.

SpankedYA!

Not that it would effect your idle but did you convert your P06 to run VTEC? Have you tried different versions of Uberdata?

B16aJunkY

I'm using 1.70 from http://uberdata.pgmfi.org/forum/index.php?board=11 there is one thing i cant find in it. is the check egine light is solid and its like the fan is backwords. it only runs when the egnition is on but when i start the car the fan wont come on even when the car is fully warmed up. and yes the vtec is checked and the vtec <20mph is checked.

SpankedYA!

You aren't understanding me. You can't run VTEC on a P06 ECU if it has not been modifed internally.

B16aJunkY

oh... i'm not sure...xenocron chiped the ecu. i told him to make sure it had vtec :/

SpankedYA!

Then its fine.

B16aJunkY

ok, is there any other reason why the engine light would be solid. and the fan wont run when the engine is on? i never tuched the fan wise in the swap of ecu's and engine swap.

SpankedYA!

Temp switch.

BoosTedZSix

solid light usually means it was a bad burn. well most of the time, does the car rev beyond 3k rpm?

SpankedYA!

Have the chip in right? Burner set right? Saved correctly?