Help with Chipping!
#1
Help with Chipping!
Okay here is the deal I have a PR4 A10 ecu and just wondering if its chippable? Because I baught a chip for it and chipped it but it only goes up to 7000rpm; the chip says it should go up to 8000rpm. Is there something I missed when I chipped it? All you have to do is unsodder the old chip and sodder in the new one right, or is there another part that I forgot?
#2
Re:Help with Chipping!
so it works fine with no check engine lights or anything? it just doesn't rev as high as you though? if this is the case, then they lied about where the rev limiter is set. did you solder the chip straight in or solder in a socket to put the chip in and out of easily?
#4
Re:Help with Chipping!
well, you're suppose to solder in in capacitors at c51 and c52, a resistor at r54, a jumper at j1 and a 74HC373 chip where it has the outline for a smaller chip appropriately labeled '74HC373'. basically, you're still running off your stock rom, is that how high it revved before you soldered the chip in?
#6
Re:Help with Chipping!
Originally Posted by DxVteC
Yes, but this is a OBD0 ecu. So you dont need to sodder in a risistor or J1 jumper.
Thread
Thread Starter
Forum
Replies
Last Post