First start with Turbo... questions
#1
First start with Turbo... questions
HEllo, I get a kit for mount a turbo, T25, in my civic hatch 5ª D16Z6,
I have the ecu chiped for NA setup, fuel map regulated according my wideband PLX250 and all ok
But I have questions before I goes to mount the turbo,,
Which fuel map I can use for the engine first start, to avoid detonation, I think first go too rich and slowly, with the PLX, correcting the fuel map lowing fuel... but How calculate the fuel to first setup knowing the psi is about 8, I expect about 200hp, stock internals, stock injectors (but with wallbro pump), fuel 98 octanes... ??
And the second question, I dont understand ignition maps, how I can adjust this map to avoid detonation? I think I have to retard the ignition, but how much?? how I can monitorize this advancing and know if the adjust is correct or is a bad adjust?
THanks a lot really & sorry for my english.
I have the ecu chiped for NA setup, fuel map regulated according my wideband PLX250 and all ok
But I have questions before I goes to mount the turbo,,
Which fuel map I can use for the engine first start, to avoid detonation, I think first go too rich and slowly, with the PLX, correcting the fuel map lowing fuel... but How calculate the fuel to first setup knowing the psi is about 8, I expect about 200hp, stock internals, stock injectors (but with wallbro pump), fuel 98 octanes... ??
And the second question, I dont understand ignition maps, how I can adjust this map to avoid detonation? I think I have to retard the ignition, but how much?? how I can monitorize this advancing and know if the adjust is correct or is a bad adjust?
THanks a lot really & sorry for my english.
#2
Re: First start with Turbo... questions
What program are you using[Uberdata,turboEdit etc}?You need to get some injectors preferably DSM 450's and then you can make a basemap for your setup and use the iginition retard feature.Your stock injectors will not work there too small.
Thread
Thread Starter
Forum
Replies
Last Post
killabee.
Forced Induction
8
10-15-2007 04:19 PM
Turblow
Fabrication
33
11-13-2006 09:19 PM
davcivic
Hybrid/Tech
15
05-11-2004 01:32 PM