CANT FIX THIS STUTTER!! TE 3 bar 450's. HELP
#1
CANT FIX THIS STUTTER!! TE 3 bar 450's. HELP
My car has this one spot and only this spot that sucks and will not adjust.
The car is an 88 crx si, a6 motor fully built stock sleeves. Running turboedit, dsm 450's, 3 bar and about 43 psi fuel pressure
At 1600-2500 rpm and -10 vacuum on the gauge the car just bucks. I can skip passed the point and the car runs fine, but if I try and cruise there the car pegs lean, 18:1 on the gauge but i cant hold it ehre cause the car bucks so I dunno what the actual y reading is
I really dunno why its asking for more fuel there as the number around it are significantly lower
Anyones guess?
Heres my bin
The car is an 88 crx si, a6 motor fully built stock sleeves. Running turboedit, dsm 450's, 3 bar and about 43 psi fuel pressure
At 1600-2500 rpm and -10 vacuum on the gauge the car just bucks. I can skip passed the point and the car runs fine, but if I try and cruise there the car pegs lean, 18:1 on the gauge but i cant hold it ehre cause the car bucks so I dunno what the actual y reading is
I really dunno why its asking for more fuel there as the number around it are significantly lower
Anyones guess?
Heres my bin
#3
Re: CANT FIX THIS STUTTER!! TE 3 bar 450's. HELP
dude what the ---- is up with your map?
half the vacuum #s are the same...they should increase gradually. the spot you are talking about bucks because you are super rich(5.81) then actually lean out a bit as you accelerate(4.85)
i think you need to start over, i bet your car runs like ---- and is hella rich with a map like that
half the vacuum #s are the same...they should increase gradually. the spot you are talking about bucks because you are super rich(5.81) then actually lean out a bit as you accelerate(4.85)
i think you need to start over, i bet your car runs like ---- and is hella rich with a map like that
Thread
Thread Starter
Forum
Replies
Last Post
Slo_crx1
Hybrid/Tech
8
08-29-2007 01:22 AM
89shithatch
Hybrid/Tech
22
02-03-2007 08:37 PM
Turblow
Engine Management
0
10-17-2006 07:27 PM