im looking for a exhaust cut out. i got one from ebay bit it has a 1 3/4" dump oultet. im running a turbo d16y8 and my downpipe is 2.5" ide like to keep the flow rate open and the same.

im looking for a cut out thats 2.5" inlet and outlet
the dump side can be 3"

manuel or electric.

please PM or e-mail me ciracingsports@hotmail.com

im located in INDIANA PA 15701

 

weld a pipe on the exhaust ofter cutting it out, drill holes through 2 flanges(around out side, drill large holes through 2. bolt together and = shhhhhhhhhh
un bolt = open DP

 

in kinda looking for a pre made y pipe that i can weld in and open manually or a electronic valve.

heres a pict.

manuel one baove

electronic one below.

 

Get a throttle body. Then research.

 

i was thinking about that last night. then i thought i was crazy. but ill look around.

 

i did no luck.

 

i have extra y8 TB that i made one out of. ill post a pict tomorrow.

 

Try Googling it with SE-R. I remember seeing it there with one guy doing that. Cheaper than the iron one you posted, better sealing, and no electric motor to fail.




Just remove the idling screw.