Heath

Since I'm parting out one of my project cars I have available my mitsubishi td07-9 turbo: t4 footprint, 13cm^2 turbine housing which equates to approximately a .97 a/r from the research I have done.
The compressor is larger than the unit on my mitsu td06 which Jerry at Deadbolt Enterprises tells me is good for 410hp.
Normal shaft play one would expect from a turbo chra with no oil pressure. Wheels are in good shape also.
The turbine housing utilizes a sort of press fit discharge pipe. I will provide the cast section of the pipe pictured so you can use that for downpipe fabrication if you don't wish to weld a v-band directly to the housing. The high nickel content housing is easily weldable.
The turbo is currently using an fd rx7 wastegate actuator (8psi spring iirc) on a custom bracket. It's internally gated but one can run external if preferred. I'll even remove the wastegate actuator assembly entirely if the buyer wishes to go external.








Nice turbo! It's kind of like a t-78's little brother.
Compressor: Inducer = 55.34mm
Exducer = 77.94mm

Turbine: Inducer = 74.05mm
Exducer = 62.83mm

$340 shipped
morganf1@charter.net

Heath

ttt