got a holley 350cfm on the toyota now (weber took a ----), and the throttle plate angle is off 90º from oem.

so, i made this:


jdm red valve cover, uber rare. you can see where i need to route the cable to, and from.



bracket made. welded a piece of 1/4" 3" exhaust pipe with half of a 3.5" OD, 3" ID washer i had floating around from a dana60 rear axle


fluxcore in all it's goodness, egr delete too . i'll take some clearer pictures tomorrow (it was dark and i had to up exposure)
the cable SHEATH is bent, it's not a sliding point for the cable. if that was the case i have ball bearing idler pulleys i'd use

 

good just as long as it doesnt stick

 

doesn't stick in the least, the sheath is the only thing that touches

 

sweet