throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
got a holley 350cfm on the toyota now (weber took a ----), and the throttle plate angle is off 90º from oem.
so, i made this: http://img.photobucket.com/albums/v3...x/IMG_0230.jpg jdm red valve cover, uber rare. you can see where i need to route the cable to, and from. http://img.photobucket.com/albums/v3...x/IMG_0231.jpg bracket made. welded a piece of 1/4" 3" exhaust pipe with half of a 3.5" OD, 3" ID washer i had floating around from a dana60 rear axle http://img.photobucket.com/albums/v3...x/IMG_0232.jpg fluxcore in all it's goodness, egr delete too :8. i'll take some clearer pictures tomorrow (it was dark and i had to up exposure) the cable SHEATH is bent, it's not a sliding point for the cable. if that was the case i have ball bearing idler pulleys i'd use O0 |
Re: throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
good just as long as it doesnt stick
|
Re: throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
doesn't stick in the least, the sheath is the only thing that touches
|
Re: throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
sweet
|
All times are GMT -5. The time now is 02:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands