throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
#1
throt cable adapter for holley carbs on toyota 22r oem cable (with fluxcore!)
got a holley 350cfm on the toyota now (weber took a ----), and the throttle plate angle is off 90º from oem.
so, i made this:
jdm red valve cover, uber rare. you can see where i need to route the cable to, and from.
bracket made. welded a piece of 1/4" 3" exhaust pipe with half of a 3.5" OD, 3" ID washer i had floating around from a dana60 rear axle
fluxcore in all it's goodness, egr delete too . i'll take some clearer pictures tomorrow (it was dark and i had to up exposure)
the cable SHEATH is bent, it's not a sliding point for the cable. if that was the case i have ball bearing idler pulleys i'd use
so, i made this:
jdm red valve cover, uber rare. you can see where i need to route the cable to, and from.
bracket made. welded a piece of 1/4" 3" exhaust pipe with half of a 3.5" OD, 3" ID washer i had floating around from a dana60 rear axle
fluxcore in all it's goodness, egr delete too . i'll take some clearer pictures tomorrow (it was dark and i had to up exposure)
the cable SHEATH is bent, it's not a sliding point for the cable. if that was the case i have ball bearing idler pulleys i'd use
Thread
Thread Starter
Forum
Replies
Last Post
Smith-02
General Discussion
48
04-04-2007 11:20 AM