d15b2 in 1991 civic relay problem

Reply Subscribe

Thread Tools

Search this Thread

Dec 14, 2005 | 03:28 PM

abakedpotato

Thread Starter

0.5 BAR

Joined: Aug 2003

Posts: 176

d15b2 in 1991 civic relay problem

i have a friend who put a d15b2 in his 91 civic which originally came with a d15b1. it was a bare block and tranny and he swapped all the harnesses and sensors from the b1 to the b2. the main relay by the drivers foot is like vibrating when the engine is turned over. he got a new one and tried it but with the same results. the engine isn't sparking but fuel is being squirted. there is also a solid cet. any suggestions?

Dec 14, 2005 | 04:59 PM

HMTguy

Guest

Posts: n/a

Re: d15b2 in 1991 civic relay problem

Your main relay is fine if you are getting fuel.

Check cap, rotor, wires, ignition module, other ---- I can't think of but someone else will say.

I have no experience with ODB0 so don't bet any money on this...

But with OBD1 if you have a solid CEL then your ecu is probably fucked up, bad wiring, bad burn if it's chipped.

Dec 14, 2005 | 05:10 PM

Dibble

1.5 BAR

Joined: Jun 2004

Posts: 752

Re: d15b2 in 1991 civic relay problem

Make sure the cap is good.
Make sure the timing is right.
Make sure the cap screw didnt come out.
Make sure the ECU is plugged in.

Dec 14, 2005 | 05:52 PM

abakedpotato

Thread Starter

0.5 BAR

Joined: Aug 2003

Posts: 176

Re: d15b2 in 1991 civic relay problem

see the thing is that the engine ran before with all the harnesses and parts (dist/sensors) on the b2, i'm not sure why it just wouldn't run on this one.